Advertisement
Quick Links
Advertisement
Related Manuals for Encore ENHGS-500
Summary of Contents for Encore ENHGS-500
- Page 1 ENHGS-500 5-Port Gigabit Switch ENHGS-800X3 8-Port Gigabit Switch User’s Guide...
- Page 2 No part of this document can be copied or reproduced in any form without written consent from the company. Trademarks: All trade names and trademarks are the properties of their respective companies. Encore Electronics Inc., Copyright © 2008, All Rights Reserved.
- Page 3 ENHGS-800X3 / ENHGS-500 provide 12K/9K (5-port / 8-port) bytes jumbo frames, which means the frames size is larger than normal 1.5K. With the Jumbo frame function, you can get better network performance, because the switch can send more data at the same time.
- Page 4 Please refer to the following table for LED definition: ENHGS-500 (5-Port switch) ENHGS-800X3 (8-Port switch) Status Operation Power Steady Green Power is on Power is off Link/ACT Steady Green Port connected Blinking Green The port is transmitting/receiving data...
- Page 5 Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table.
- Page 6 Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full duplex operation and flow control Interface 5X / 8X - 10/100/1000 Mbps RJ-45 Gigabit Ethernet ports Uplink Auto MDI/MDI-X（Auto crossover） Network 10/100/1000Mbps & Full/Half duplex mode Speed auto detection (1000Mbps for Full duplex only) 1K MAC entries (5-port) Address...