Page 3
The switch is plug-n-play without any software to configure and also fully compliant with all kinds of network protocols. Before you start to install the switch, check the following contents in this package: One ENHGS-800X3 Gigabit Ethernet switch One External Power Adapter Users Manual...
Page 4
Please refer to the following table for LED ports assignments: Status Operation Power Steady Green Power is On Power is Off Link/ACT Steady Green Port is connected Blinking Green The port is transmitting/receiving data 61E2-G208E0+204...
Page 5
Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table.
Page 6
Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full duplex operation and flow control Interface 8X 10/100/1000Mbps RJ-45 Gigabit Ethernet ports Uplink Auto MDI/MDI-X Auto crossover Network 10/100/1000Mbps & Full/Half duplex mode auto Speed detection (1000Mbps for Full duplex only) MAC Addr.