Operation - Dual XHD7714 - V3 Installation & Owner's Manual

Overview
The XHD7714 supports the HFP (hands-free profile), A2DP (advanced audio distribution
profile) and AVRCP (audio video remote control profile).
Preparation
Before you can use a mobile device with this head unit, it must be connected and
authenticated - commonly referred to as "pairing" a device. Please make sure that
Bluetooth is activated on your mobile device before you begin the pairing process. Refer
to the owner's manual of your mobile device for more details.
Bluetooth Pairing
1) To pair a Bluetooth enabled mobile phone to your head unit, press
or press MODE until "BLUETOOTH" scrolls once then "STANDBY" is displayed.
2) Press and hold
Bluetooth icon will flash every second. The head unit will begin to broadcast a signal for
90 seconds.
3) Complete the pairing from the Bluetooth menu of your mobile device by searching for
new devices. Please refer to your mobile device instructions for further information on
Bluetooth pairing and connections. The Bluetooth icon will illuminate solid.
The XHD7714 device name is "DUAL BT."
The password for the DUAL XHD7714 is 1234.
Connection Notes
• If AUTO-CON is set to OFF, you must press
• From Bluetooth standby mode, press
• From Bluetooth standby mode, press
• To connect a different mobile device, the currently connected mobile device must be
disconnected. If this device has been paired previously, you may reconnect using the
mobile device's Bluetooth menu, or repeat the above pairing instructions.
General Note
• Due to the differences in Bluetooth technology, some mobile devices may be
incompatible or function improperly when used with the XHD7714.
• The Bluetooth microphone is built into the front panel of the XHD7714.
on the head unit for 5 seconds, until "PAIRING" is displayed, the
XHD7714 OPERATION
Bluetooth
to connect after pairing.
to disconnect your mobile device.
to reconnect your mobile device.

Operation

®
on the head unit,
25