If no data is stored in the scan tool, above prompt will not
show up.
8) If you wish to erase the data, press ENTER button; if you do not
want to erase the data, press ESC or use LEFT/RIGHT button to
select NO and press ENTER to continue.
9) View a summary of system status (MIL status, DTC counts,
Monitor status) on screen. Wait a few seconds or press any key
for Diagnostic Menu to come up.
If more than one module is detected, you will be prompted to
select a module before testing.
Diagnostic
Erase previously
stored data to save
data from this test?
YES
System Status
MIL Status
Codes Found
Monitors N/A
Monitors OK
Monitors INC
Control Module
Engine
►
Module $A4
26
NO
ON
6
3
3
5
1/2
?