Table of Contents
Advertisement
5） Press ENTER button to enter Main Menu. Use UP/DOWN
scroll button to select Diagnostics from the menu.
6） Press ENTER button to confirm. A sequence of messages
displaying the OBD2 protocols will be observed on the display
until the vehicle protocol is detected.
If the scan tool fails to communicate with the vehicle's ECU
(Engine Control Unit), a "LINKING ERROR!" message
shows up on the display.
Verify that the ignition is ON;
Check if the scan tool's OBD II connector is securely
connected to the vehicle's DLC;
Verify that the vehicle is OBD2 compliant;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and repeat the procedure from step 5.
If the "LINKING ERROR" message does not go away, then
there might be problems for the scan tool to communicate
with the vehicle. Contact your local distributor or the
manufacturer's customer service department for assistance.
7） You will be prompted to erase previously stored data.
Review previously stored data thoroughly before erasing.
Main Menu
Diagnostics
►
DTC Lookup
Review Data
Print Data
System Setup
Tool Information
25
1/6
?
Hide quick links:
Advertisement
Table of Contents
