McAfee EPOLICY ORCHESTRATOR 3.6 - WALKTHROUGH GUIDE Manual page 86

®
ePolicy Orchestrator 3.6 Walkthrough Guide
HTTP Configuration
12 On the
82 Console-to-Server communication port
and the
Figure 8-1 HTTP Configuration dialog box
Some HTTP ports (ports 80 and 81 in particular), are commonly used by many HTTP
applications and services. Because of this, port 80 may already be in use and not
available. McAfee recommends changing the port number to avoid any conflicts.
Next
13 Click to save the port information.
If you do see a warning message saying that one or more HTTP ports are in use,
OK
click and repeat Step
Set E-mail Address
14 On the dialog box, type the e-mail address to which the default
notification rules send messages once they are enabled.
This e-mail address is used by the ePolicy Orchestrator Notifications feature. This
feature is covered in this guide, so enter an e-mail address that receives messages
you can view.
Ready to Install
15 On the dialog box, click
The installation takes approximately 20 minutes to complete and may prompt you
to reboot the system during the installation.
OK
16 Click when prompted to reboot and be sure to log back in when the system
reboots to allow the installation to continue.
17 When the installation is finished, click
Once the installation is complete, you can open the ePolicy Orchestrator console to
begin deploying agents and anti-virus products to the client systems in your network.
Agent-to-Server communication port
dialog box, change the
83
to .
12, this time specifying unused HTTP ports.
Install
to begin the installation.
Finish
.
83
8
Installing and setting up
to