McAfee EPOLICY ORCHESTRATOR 3.6 - WALKTHROUGH GUIDE Manual page 118

®
ePolicy Orchestrator 3.6 Walkthrough Guide
Notifications
1 Click in the console tree, then select the
tab in the details pane.
Figure 9-1 Basic Configuration
E-mail Server
2 Under , type the name of a mail server to which the ePolicy Orchestrator
server can route, and the desired e-mail address that you want to appear in the
line of the message.
When you decide which e-mail address to place here you should consider the number
of administrators who may receive notification messages, and whether you want
these administrators to be able to send reply messages.
Note
Apply E-mail Contacts
3 Click , then click
specify all of the addresses to include in the address book from which you will select
recipients during rule creation.
There should be one contact in the list already,
Administrator
provided for
panel of the installation wizard. If you did not change the default address in the
Administrator@example.com
wizard, the address is
one that you are not able to view the mail sent to it, then click the address and
change it to one at which you can receive and view e-mail messages.
Configuration
From the
like to receive SNMP traps and external commands that you want to run
when certain events are received. These tasks are beyond the scope of this
Note
guide. For more information, see the ePolicy Orchestrator 3.6 Product
Guide.
Now that you've specified an e-mail server to be used to send the message, and an
address to receive the message, you are ready to create a rule to trigger on a
VirusScan Enterprise event.
Configuration | Basic Configuration
at the top of the tab. This page allows you to
Administrator
is the e-mail address you entered in the
. If the address for
tab you can also define SNMP servers at which you'd
115
Advanced Feature Evaluations
ePolicy Orchestrator Notification
From
. The e-mail address
Set E-mail Address
Administrator
is
9