Sony UP-DR200 Operating Instructions Manual page 14

Attaching the Output Tray Adapter
The output tray adapter prevents printouts from sticking
out of the output tray.
Use the adapter when printouts curl as shown.
Note
About 20 printout sheets can be stored in the output tray
in most cases. However, this number can vary greatly
depending on the amount of curling in printouts. In
general, you should remove ejected printouts as soon as
possible.
Adjust the position of the output stopper according to
the printing pack in use and the amount of curling in
printouts. There are four positions to which to adjust.
Note
If the output stoppers are not positioned correctly, paper
jams may occur.
When using the 2UPC-R203 series or
2UPC-R204 series printing pack
Set the output stopper to the top position.
14
Loading the Paper Roll and Ink Ribbon
When using the 2UPC-R205 series printing
pack
Set the output stopper to the third position from the top.
If there is a large amount of curling in the printouts, set
the stopper to second position from the top.
When using the 2UPC-R206 series printing
pack
Set the output stopper to the bottom position.
If there is a large amount of curling in the printouts, set
the stopper to second position from the bottom.