Sony UP-DR200 Operating Instructions Manual page 17

6
Pull the ribbon door toward you to open it.
7
Remove the ribbon tray.
8
Remove the ink ribbon.
After removing the ink ribbon, attach the black
spool to the white spool.
Do not reuse ink ribbons that have reached their
prescribed print capacities and have been removed.
Note
The ribbon tray is reusable. Do not throw it away.
If you have to replace a partially used
printing pack
We recommend replacing ink ribbons and paper rolls
with new printing packs only when the predetermined
number of sheets is used up.
If you have to replace a partially used ink ribbon and
paper roll, proceed as follows to replace the partially
used ink ribbon and paper with new ones.
Note
If you replace a partially used ink ribbon and paper, the
remaining amount of ink ribbon displayed may not be
correct.
1
Press and lower the paper door lever, and pull the
paper door toward you until it locks into the open
position.
2
Remove the paper roll.
3
Wind the paper roll tightly, and attach a piece of
adhesive tape to prevent loosening.
4
Open the ribbon door.
5
Remove the ribbon tray, and replace the ink ribbon.
6
Load the ribbon tray into the printer, and close the
ribbon door.
7
Load the paper roll supplied with the ink ribbon
loaded in step 5, and close the paper door.
Be sure to retain the removed paper roll and ink
ribbon as a pair.
Note
If you replace ink ribbon and paper roll which have been
partially used, paper equal to several sheets are wasted
and you may not be able to print the number of sheets
specified.
For detailed information on the number of sheets that
can be printed, see "Printing capacity" on page 27.
Loading the Paper Roll and Ink Ribbon
17