Sony UP-DR200 Operating Instructions Manual page 12

7
Close the paper door, and press the center of the
door until it clicks into place.
Notes
• If you close the door by pressing only its sides,
the door may not lock into place properly.
• When closing the paper door, be sure that the
front edge of the paper is not caught in the door.
To load the ink ribbon
1
Pull the ribbon door toward you to open it.
2
Remove the ribbon tray.
12
Loading the Paper Roll and Ink Ribbon
Note
After removing the ribbon tray, do not insert your
hand into the opening in the printer. Touching the
protrusions or movable parts inside the printer may
result in bodily injury or malfunction of the printer.
In particular, touching the thermal head when it is
hot immediately after printing may result in burns.
3
Detach the white spool of the ink ribbon from the
black spool.
4
Gently unravel the ribbon without loosening it, and
place it in the ribbon tray.
Place the white spool in the front holder and the
black spool in the rear holder as shown.
Note
If the ink ribbon is loosely raveled around the
spools or there is any slack or creases in the ink
ribbon, wind the spools to tighten the slack and
smooth out the creases.