Device Settings; Usable Device Specific Settings - Epson C390999 - TM T90 Color Thermal Line Printer Development Manual

4) Port information when using Ethernet port
The port information that can be set with the SetupPOS utility is as follows.
Output buffer length [byte]
Output interval time [ms]
The default settings are as shown in the following table.
Output buffer length [byte]
Output interval time [ms]

2.4 Device Settings

The following explanation is about the settings for TM-T90.

2.4.1 Usable Device Specific Settings

For the TM-T90, the following device specific settings are settable by the
SetupPOS utility. For the detail, please refer to the Section 2 of "EPSON OPOS
ADK MANUAL APPLICATION DEVELOPMENT GUIDE POSPrinter (TM
Series)".
Tab
General
Paper
Bitmap
Color Bitmap
Item
Item
Disable panel buttons
Assume print complete when data output finishes
Ignore firmware version check
Homogenize Error Codes
Output complete timeout
Paper Type
Paper Width [mm]: LineWidth [dot]: LineCharsList
TMFlogo...
Method
Brightness
Primary
Secondary
6
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-T90)
Version 2.61 Feb. 2008
Setting range
32 to 1024
0 to 9999
Setting range
1024
2500
Settings