Tractor Requirements; Rops And Seat Belt; Tractor Safety Devices - Alamo SHD62 Operator's Manual

3. TRACTOR REQUIREMENTS

The tractor used to operate the mower must have the power, capacity and required equipment to safely
operate the mower at a ground speed between 2 and 5 MPH. Operating the mower with a tractor that does not
meet the following requirements may cause tractor or mower damage and could be a potential danger to the
operator and passersby.
Tractor Requirements and Capabilities
• ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
• Tractor Safety Devices ..................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
• Tractor Horsepower-Minimum.......... SHD62-20 HP, SHD74-35 HP, SHD88-40 HP, SHD96-50HP
• 3-Point Hitch-Lifting Capacity ........... SHD60-815 lbs., SHD72-930 lbs.,SHD88-1035 lbs., SHD96-1170 lbs.
• Category.............. SHD60 - CAT I and SHD74, SHD88, SHD96, CAT I or CAT II
• Front End Weights............................ As needed to maintain 20% weight on tractor front axle
• Power Take Off................................. 540 RPM-6 spline

3.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.

3.2 Tractor Safety Devices

If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement.
with the PTO master shield missing or in the raised position. OPS-U- 0004
SHD 03/09
© 2009 Alamo Group Inc.
OPERATION
Operation Section 4-6
(SG-7)
Never operate the tractor PTO