Controller Automation; Reset All Controllers; Midi Clock And Clock Commands; Dynamic Midi - Lexicon PCM 80 - MIDI IMPLEMENTATION DETAILS Midi Implementation Manual

PCM 80 MIDI Implementation Details

Controller Automation

For applications where it is desirable to "automate" changes made to PCM 80 effects with its own controls
( ADJUST knob, Foot Pedal , Footswitch 1 or Footswitch 2), we recommend assigning the controllers to
MIDI destinations and recording the changes with a MIDI sequencer (see Control Mode parameter 3.5,
MIDI Destinations).

Reset All Controllers

The PCM 80 recognizes the "Reset All Controllers" message. When received, all patched parameters are
reset to their stored values. Patched parameters may also be reset from the PCM 80 front panel —Control
Mode parameter 3.0. The message will also be transmitted from the PCM 80 on its transmit channel.

MIDI Clock and Clock Commands

The PCM 80 recognizes MIDI clock messages when Tempo Mode parameter 0.2, Tempo Source is set
to MIDI. Any Delay or LFO parameter set to display tempo values will be synchronized to the tempo of
the incoming MIDI clock.
MIDI Clock and Clock Commands are also available as Dynamic MIDI patch sources. The value of MIDI
Clock when used as a patch source is a linear scaling of 0 to 127 (0 = 40 BPM and 127 = 400 BPM). The
value of Clock Commands when used as a Dynamic MIDI patch source is 1 for START and CONTINUE
and 0 for STOP.

Dynamic MIDI

The following MIDI messages are available as Dynamic MIDI patch sources:
MIDI Controllers 1-119
Pitch Bend (most significant 7 bits)
After Touch (Polyphonic and Channel combined)
Velocity (Note On)
Last Note
Low Note
High Note
Tempo (Linear scaled value is always available, and
will reflect the selected source: Internal or MIDI.)
Clock Commands
These MIDI messages are also available as threshold sources for several Modulation parameters: AR
Env, Latch, Sw 1 and Sw 2. They may also be used as a tap source for controlling Tempo.

Bulk Data Dumps

Control mode 3.8 (MIDI Dump) allows selection of the following types of bulk data to be dumped directly
from the PCM 80 to another PCM 80, or to editor/librarian software.
Displayed Name
CurrentPgm
Bank R
Bank C0-CK
Map 0, 1
Map 2-33
Chain 0-9
Chain 10-19
Int Chains
Ext Chains
Setup C
Setup 0-4
Setup 5-9
Use ADJUST to select the bulk data type. Press Store to transmit the data .
2
Description
Currently running effect
Internal Register Bank
Card Banks (card must be inserted)
Internal Program Change Maps
Card Program Change Maps (card must be inserted)
Internal Program Chains
Card Program Chains (card must be inserted)
All Internal Program Chains
All Card Program Chains (card must be inserted)
Current Setup
Internal Setups
Card Setups
Lexicon