Lexicon MPX G2 V1.1 - INSTALLATION AND RELEASE NOTES Installation Instructions Manual page 7

MPX G2
4. Press the front panel > Yes 11 button times, until the
MIDI Dump option is selected as shown in the figure
below. The front panel Store button LED will flash to
indicate that the MPX G2 is armed to transmit a
MIDI dump.
5. Rotate the front panel selection knob to the right
until the All Programs option is selected as shown in
the figure below.
Software Version 1.1 Installation Instructions & Release Notes
6. Press the front panel Store button to send this dump
to the designated external MIDI storage device.
When the dump is in progress, the front panel
display will appear as shown in the figure below.
7. When the All Programs dump is complete, repeat
steps 4, 5, and 6 until all of the following MIDI dump
options have been executed: Map 1, Map 2, Map 3,
Chain 1, Chain 2, Chain 3, Chain 4, Chain 5, Chain
6, Chain 7, Chain 8, Chain 9, Chain 10, Setup 1,
Setup 2, Setup 3, Setup 4, and Setup 5.
8. Follow the instructions that begin on the next page
to install Software Version 1.1.
. . . Preserving User Bank Programs & System Settings continues on page 8
7