Maintenance And Service Safety Instructions And Practices - Alamo Interstater 803213C Operator's Manual

Maintenance and Service Safety Instructions and Practices

Make sure the PTO shield, integral driveline shields, and input shields
are is installed when using PTO-driven equipment. Always replace any
shield if it is damaged or missing.
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement.
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause
immediate entanglement, injury or death.
All Safety Shields, Guards and Safety devices including (but not limited
to) - the Deflectors, Steel Guards, Gearbox Shields, PTO integral
shields , and Retractable Door Shields should be used and maintained
in good working condition. All safety devices should be inspected carefully at least daily
for missing or broken components. Missing, broken, or worn items must be replaced at
once to reduce the possibility of injury or death from thrown objects, entanglement, or
blade contact.
(SFL-5)
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
INTERSTATER 03/09
© 2009 Alamo Group Inc.
SAFETY
(S3PT-8)
Place the Implement on the ground or securely
(S3PT-09)
(S3PT-11)
Do not permit anyone to modify or alter this
(SG-14)
(SG-20)
Safety Section 1-13
(SG-5)
(SG-8)