Bent Mount (Dcs-33-4) - D-Link DCS-6510 User Manual

User manual

Hide thumbs Also See for DCS-6510:

Table of Contents

Installation

1. Locate a suitable position on the wall for a 34 mm (+2 / –0 mm) hole to be cut. A

template is included to aid in marking the mounting hole.

2. Cut the hole in the wall according to the template

3. Drill 4 separate 6 mm holes corresponding to the holes in the mounting template and

insert the plastic anchors into these holes.

4. Place the rubber seal between the bent bracket and the wall to ensure a waterproof

seal between the wall and the bracket.

5. Attach the bent bracket to the wall using the screws provided.

6. Place the rubber washer into the hole at the top of the bracket cap to ensure a

waterproof seal between the cap and the bracket.

7. Attach the bracket cap to the bottom of the bent bracket, rotating the cap counter-

clockwise to tighten it into place.

8. Insert the screw into the base of the bent bracket at the top of the bracket cap to

secure the bracket cap into place.

D-Link DCS-6510 User Manual

Bent Mount (DCS-33-4)

Bent

Bracket

Cap

Table of Contents