D-Link DCS-6510 User Manual page 9

Installation
6. Cut the zip-tie at the base of the cables if needed.
7. Use a metric size 21 wrench to loosen the chrome
nut where the cable exits the base of the camera.
8. Remove the cable with the nut attached.
9. Loosen and remove the chrome plug from the base
of the camera using a coin or screwdriver.
10. Place the cable into the new hole and reconnect the
cable connectors to the circuit board.
11. Replace the chrome plug and tighten it into place.
12. Replace the chrome nut and tighten it into place
B. Replace the dome enclosure over the IP camera and
tighten the 4 screws.
C. Insert and tighten the 3 mountings bolts in the holes on
the back panel of the camera, as shown here.
Safety Notice:
Installation and servicing should be done by certified
technicians so as to conform to all local codes and prevent
voiding your warranty.
D-Link DCS-6510 User Manual
Mounting Bolts
Chrome Nut
Chrome Plug
Figure 5.
Figure 6.
9