Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 798

Configuring ASLB
Clearing the ASLB Configuration
If you do not enter any keywords with the clear lda command, the entire ASLB configuration is
Caution
removed from the hardware and NVRAM along with the MLS entries. If you do not enter any
keywords with the clear lda mls command, all MLS entries are cleared.
To clear ASLB entries or router MAC addresses, perform this task in privileged mode:
Task
Clear ASLB configuration settings.
This example shows how to clear the MLS entry at a specific destination address:
Console> (enable) clear lda mls destination 172.20.26.22
MLS IP entry cleared.
Console> (enable)
This example shows how to delete a virtual-IP address and port pair (10.0.0.8, port 8):
Console> (enable) clear lda vip 10.0.0.8 8
Successfully deleted vip/port pairs.
Console> (enable)
This example shows how to clear all ASLB router MAC addresses:
Console> (enable) clear lda mac all
Successfully cleared Router MAC address.
Console> (enable)
This example shows how to clear a specific ASLB router MAC address:
Console> (enable) clear lda mac 1-2-3-4-5-6
Successfully cleared Router MAC address.
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
42-18
Command
clear lda mls
clear lda mls [destination ip_addr_spec] [source
ip_addr_spec] [protocol protocol src-port src_port
dst-port dst_port]
clear lda vip {all | vip | vip tcp_port}
clear lda mac {all | router_mac_address}
Chapter 42 Configuring ASLB
78-13315-02