Configuring 802.1Q Tunnel Ports; Clearing 802.1Q Tunnel Ports; Removing Global Support For 802.1Q Tunneling - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring Support for 802.1Q Tunneling
This example shows how to configure tunneling on the switch and verify the configuration:
Console> (enable) set dot1q-all-tagged enable
Dot1q tagging is enabled
Console> (enable) show dot1q-all-tagged
Dot1q all tagged mode enabled
Console> (enable)

Configuring 802.1Q Tunnel Ports

To configure 802.1Q tunneling on a port, perform this task in privileged mode:
Task
Step 1 Configure tunneling on a port.
Step 2
Verify the configuration.
This example shows how to configure tunneling on port 4/1 and verify the configuration:
Console> (enable) set port dot1qtunnel 4/1 access
Dot1q tunnel feature set to access mode on port 4/1.
Port 4/1 trunk mode set to off.
Console> (enable) show port dot1qtunnel 4/1
Port
-----
4/1

Clearing 802.1Q Tunnel Ports

To clear 802.1Q tunneling support from a port, perform this task in privileged mode:
Task
Step 1 Clear tunneling from a port.
Step 2 Verify the configuration.
This example shows how to clear tunneling on port 4/1 and verify the configuration:
Console> (enable) set port dot1qtunnel 4/1 disable
Dot1q tunnel feature disabled on port 4/1.
Console> (enable) show port dot1qtunnel 4/1
Port
-----
4/1

Removing Global Support for 802.1Q Tunneling

You do not need to enter the set dot1q-all-tagged disable command to clear 802.1Q tunneling. The set
port dot1qtunnel disable command is the only command required to clear the feature from the port.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
7-4
Dot1q tunnel mode
-----------------
access
Dot1q tunnel mode
-----------------
disabled
Chapter 7 Configuring IEEE 802.1Q Tunneling
Command
set port dot1qtunnel {mod/port} access
show port dot1qtunnel [mod[/port]]
Command
set port dot1qtunnel {mod/port} disable
show port dot1qtunnel [mod[/port]]
78-13315-02