Cabling Guidelines; Configuring Aslb; Configuring The Localdirector Interfaces - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 42

Configuring ASLB

Table 42-5 Server to Client ASLB Layer 3 Table Entries
IP Destination IP Source
Address Address
1 2
VIP CIP
CIP VIP
1. VIP = virtual-IP address.
2. CIP = client's IP address.
3. MAC address of the server that the LocalDirector selected.

Cabling Guidelines

Follow these cabling guidelines for your ASLB configuration:
•
•
Connect the LocalDirector directly to the Catalyst 6000 family switch.
Caution
See the
interfaces. See the
Configuring ASLB
This section lists the tasks necessary to configure ASLB:
•
•
To implement these tasks, follow the guidelines and use the detailed configuration procedures in the
sections that follow.

Configuring the LocalDirector Interfaces

Refer to the Cisco LocalDirector Installation and Configuration Guide, Version 3.2, for detailed
information on configuring the LocalDirector interfaces for ASLB.
78-13315-02
Protocol
TCP
TCP
Check your connections to the servers attached to the switch. The servers must be either directly
attached to the switch or within the same bridging domain as the LocalDirector port in the server
VLAN.
Use two Category 5 unshielded twisted-pair cables to connect two 10/100 or two 1000BASE-X
switch ports to two comparable LocalDirector interfaces.
"Configuring the LocalDirector Interfaces" section on page 42-7
"Configuring ASLB from the CLI" section on page 42-11
Configuring the LocalDirector Interfaces, page 42-7
ASLB Configuration Guidelines, page 42-8
Ports VLAN
80/YZ 20
YZ/80 10
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Cabling Guidelines
MAC Destination MAC Source
Address Address
3
Server MAC Router MAC
Router MAC LocalDirector
MAC
to configure the LocalDirector
to configure the switch.
42-7