NETGEAR WG111UNA - DOUBLE 108MBPS WRLS USB 2.0 User Manual page 40

User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
5. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
On the Windows taskbar click the Start button, and then click Run.
a.
Figure 4-3: Windows Run program dialog box
Assuming the target PC is configured with 192.168.0.1 as its IP address, type
b.
192.168.0.1
This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
c.
address. The ping response should change to "reply."
Figure 4-4: Ping test results
At this point the connection is established.
You may need to reboot in certain Windows operating systems such as Windows 98SE.
Note: If you cannot connect, see
accessing network resources, Windows Client and File and Print Sharing software might not
be installed and configured properly on your computers. Please refer to
Computers for TCP/IP Networking" on page
4-6
and then click OK.
Chapter 4,
202-10026-01
"Troubleshooting". Also, for problems with
C-1.
ping -t
"Preparing Your
Configuration