Table of Contents
Advertisement
User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
For example, if you use your notebook PC to connect to a wireless network in an office and a
wireless network in your home, you can create a profile for each wireless network. Then, you can
easily load the profile that has all the configuration settings you need to join the network you are
using at the time.
There are two types of wireless network connections you can configure:
•
Infrastructure Mode — uses the 802.11 infrastructure mode.
•
Ad Hoc Mode — uses the 802.11 Ad Hoc mode
For more information on 802.11 wireless network modes, see
on page B-1
of this manual.
Connecting to an Access Point in Infrastructure Mode
This section provides instructions for configuring the NETGEAR 54 Mbps Wireless USB 2.0
Adapter WG111 to connect to a wireless access point or wireless router.
How to Configure an Infrastructure Mode Profile
Follow the instructions below to configure an infrastructure mode profile for connecting to an
access point.
1. Run the WG111 Wireless Assistant.
Make sure the WG111 software is installed and the WG111 is connected to your PC.
a.
Open the Wireless Assistant by clicking on the WG111 icon
b.
system tray.
Click the Settings tab to display the view shown below.
c.
4-2
"Wireless Networking Overview"
202-10026-01
in the Windows
Configuration
Advertisement
Table of Contents
