Table of Contents
Advertisement
The WG111 Wireless USB 2.0 Adapter comes with 3 pieces of velcro. Locate the one that has
1.
a prickly side and attach it to the plastic cradle on the middle of the outside rear panel.
Figure 3-2: Plastic cradle
Insert the WG111 Wireless USB 2.0 Adapter in the plastic cradle.
2.
Place one of the other pieces of velcro on the back of your notebook monitor near the top for
3.
better reception.
Note: The last piece of velcro can be placed on the side of your desktop PC monitor nearest
your wireless access point, if you are using the USB Adapter with a desktop PC.
Join the pieces of velcro to attach the USB Adapter in the plastic cradle to the notebook
4.
monitor.
Attach one end of the USB cable to the USB drive. See the installation instructions for your
5.
operating system before attaching the other end of the USB cable to your computer.
•
For Windows XP, see
•
For Windows 2000, 98SE, and Me, see
WG111" on page
Two Basic Operating Modes
The WG111 Wireless USB 2.0 Adapter can operate in the following two basic modes:
•
Infrastructure Mode
communicate with each other by first going through an access point (AP). For example, this
mode is used when computers in a house connect to an Access Point that is attached to a router
which lets multiple computers share a single Cable or DSL broadband Internet connection.
Basic Setup
User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
"For Windows XP Users Installing a WG111" on page
3-9.
: An 802.11 networking framework in which devices and computers
202-10026-01
"For Windows 2000 & 98SE/Me Users Installing a
3-5.
3-3
Advertisement
Table of Contents
