Set Up Cubase Le 4 For Use With The I•Onix U82S; (Windows ® ) - Lexicon I-ONIX U82S Owner's Manual

Set Up Cubase LE 4 for Use with the I•ONIX U82S
®
(Windows )
®
1. Make sure the included USB cable is connected to your computer and to
the U82S and the U82S is turned on.
2. Start Cubase ® LE 4 (from the Start menu under Lexicon
3. If you see the warning shown below, click OK.
4. Once you are in Cubase LE 4, go to Devices>Device Setup.
5. Under Devices, click on VST Audio System and select Lexicon I•ONIX
U82S from the ASIO Driver pull-down menu if it is not already selected.
Click on Switch to switch the driver, then click OK in the Device Setup
dialog. You are now ready to begin recording using your U82S and
Cubase LE 4.
Note: In many cases you can improve performance by selecting a higher
latency setting from the System Performance drop-down menu on the
ASIO control panel (Devices > Device Setup > Lexicon I•ONIX U82S >
Control Panel > ASIO).
® ).
15