Set Up Cubase ® Le For Io 42 (Windows ® ) - Lexicon I-O|42 Owner's Manual

16
Set Up Cubase LE for IO 42 (Windows
®
1. Make sure the included USB cable is connected to your computer and to
the IO 42 and the IO 42 is turned on.
2. Start Cubase ® LE (from the Start menu under Lexicon
3. If you see the warning shown below, click OK.
4. Once you are in Cubase LE, go to Devices>Device Setup.
5. Under Devices, click on VST Audio System and select Lexicon IO 42
from the ASIO Driver pull-down menu if it is not already selected. Click
on Switch to switch the driver, then click OK in the Device Setup dialog.
You are now ready to begin recording using your IO 42 and Cubase LE.
Note: In many cases you can improve performance by selecting a higher
latency setting from the System Performance drop-down menu on the ASIO
control panel (Devices > Device Setup > Lexicon IO 42 > Control Panel
> ASIO).
)
®
® ).