Table of Contents
Advertisement
By default, the VFO frequency will jump to the low band edge of the current band when the
VFO frequency reaches the high band edge. You may change the scanner operation so that
the VFO frequency will change to downward scanning when the VFO frequency reaches
the high band edge.
1. Press and hold the [ VOL/SEL ] key for one second to activate the Menu mode.
2. Rotate the DIAL knob to select Menu Item "F31 SCN DRCT".
3. Press the
key to enable selection of this Menu Item.
4. Rotate the DIAL knob to set the desired scan mode.
NORMAL:When the VFO frequency reaches the high band edge of the current band, the
VFO frequency will jump to the low band edge of the current band (or vice
versa).
RETURN: When the VFO frequency reaches the high band edge of the current band
while scanning upward, the scanner will reverse direction and scan down-
wards. (or vice versa).
5. Press the [ VOL/SEL ] key to save the new setting and exit to normal operation.
By default, the scanner initiates scanning upward when activates the scanner by pressing
the top panels'
1. Press and hold the [ VOL/SEL ] key for one second to activate the Menu mode.
2. Rotate the DIAL knob to select Menu Item "F33 SCN STRT".
3. Press the
key to enable selection of this Menu Item.
4. Rotate the DIAL knob to set the desired direction.
UP START:
DWN.TRART: the scanner initiates scanning downward.
Press the [ VOL/SEL ] key to save the new setting and exit to normal operation.
FTM-10SR O
PERATING
M
ISCELLANEOUS
S
CAN
S
S
CAN
key. You may change the scan start direction to downward scanning.
the scanner initiates scanning upward.
M
ANUAL
D
IRECTION
D
TART
IRECTION
S
ETTING
81
Advertisement
Table of Contents
