Advertisement
5. On your computer desk top open PEP950_EDSP folder and find the EDSP-301 icon as shown
below. Double-click the EDSP-301 icon, displayed on the Program Screen.
6. Click the Update button. You will see AH031_V1153 out file displayed. If you do not see
AH031_V1153 (as in the screen below), then open the "Look in:" window and go to the desktop
and find PEP950_EDSP. Open the folder and AH031_V1153 will be displayed in the window.
Click AH031_V1153 out file to
program is loaded, and 100% is indicated on the bar graph, [completion!!] will be displayed.
7. Turn OFF the front Power Switch and disconnect the DC power cable (or turn OFF the power
supply for FT-950 and wait a minute, until the capacitors discharge). This resets the radio and
locks in the new software. Remove the DB9F to DB9F cable. The updating process is now
complete.
After the update, it is important to reset the FT-950. Plug the radio back in. Press and hold in
the [FAST] and [LOCK] keys; while holding them in, turn the radio back on (this resets the
radio and locks in the new software).
NOTE: We recommend trying the new factory default settings rather than transferring your old ones,
because of the changes in the EDSP and the Main CPU, you may wish to make new settings.
highlight
it. Then click the Open button and wait until the
NOTE: If you receive a "communications
error" message on your screen you should
check the COM port number and speed under
Device Manager. The writing speed
38.4kbps is fixed in the download algorithm
of the EDSP board so you may need to set
the port speed close to 38.4kbps. Click on the
COM Select box arrow and choose a
different COM port from the drop down
menu in the EDSP-301 writer.
Advertisement
