Table of Contents
Advertisement
MAINTENANCE
STEP 5
The Input Gear and Bearing can be removed from the Input Shaft by tapping the end of the Input Shaft on a
solid surface. FIGURE Mnt-R-0052.
The unit is now completely disassembled with exception of Oil Seals and Bearing Races that can be removed
by conventional means. FIGURE Mnt-R-0053.
Inspect and replace all worn or defective parts.
Assembly of WW75-340
STEP 1
Install the Bearing Race into the Hub cap.
STEP 2
Install the Bearing on the Output Shaft. FIGURE Mnt-R-0054. Place the Shaft into the Hub Cap. FIGURE
Mnt-R-0055. Place the Bearing FIGURE Mnt-R-0056 on the Shaft and carefully drive it down FIGURE Mnt-R-
0057. Replace any shims found in disassembly, Place the Gear FIGURE Mnt-R-0058 on the Shaft so that the
threads, for the Adjusting Nut, on Shaft are exposed.
Eagle 20 03/09
Maintenance Section 5-23
© 2009 Alamo Group Inc.
Advertisement
Table of Contents
