Using The Machine With A Answering Machine; Quiet Detecttime - Sharp 3800M - B/W Laser - All-in-One Operation Manual

Using the Machine with an Answering Machine
Quiet Detect Time
Quiet Detect Time is the function that enables the machine to be used along
with an answering machine for both phone messages and faxes. After the
answering machine has answered, any duration of silence longer than a certain
threshold time will prompt the machine to take over the line and prepare to
receive a fax. The Quiet Detect Time can be set from 00 to 10 seconds,
following the procedure below.
Factory setting: 05
Step Press these keys
1
FUNCTION
2
3
4
ENTER
STOP
5
Notes:
• The machine has been set at the factory for a Quiet Detect Time of 5 seconds,
which gives the best performance for most answering machines. However,
you may have to adjust the Quiet Detect Time depending on your answering
machine's disconnect time, the time before the machine disconnects the line
after a period of silence. If your machine has a short disconnect time, you
may have to shorten the Quiet Detect Time. However, if the machine is
interrupting callers in the middle of messages, you should set a longer Quiet
Detect Time.
• If there is a pause at the end of your answering machine message, make
sure that the Quiet Detect Time is longer than this pause.
• Setting Quiet Detect Time to 00 turns the function off. However, the machine
will not be able to receive faxes sent using manual dialing (picking up the
receiver, dialing the number, and pressing the FAX START key when the fax
tone is heard).
SUK 06 INITIAL LEO.p65
TUV
to
STOP
INITIAL SETTINGS
63
Comments
"A.M. MODE" will appear
in the display.
"QUIET DETECT TIME"
will appear in the display.
Enter the Quiet Detect
Time in seconds, from 00
to 10.
(Setting "00" turns off
Quiet Detect Time)
"STORED" will appear in
the display.
Press the STOP key twice
to exit.
30/03/00, 17:01
6
63