Tutorial; Make Connections - DigiTech TIME BENDER Owner's Manual

Tutorial

This section walks you through some basic functions and helps you get familiar with
the controls. It also gives you an idea of what the TimeBender
Tutorial uses the Mono In/Mono Out setup, as shown below.

Make Connections

Before connecting the TimeBender, make sure that the power to your amplifier or
P.A. is off and that the TimeBender is powered on. There is no power switch on the
TimeBender. To turn the TimeBender on or off, connect or disconnect the included
PS0913B power supply from the Power Supply jack.
1. Connect your guitar to the Left (Mono) Input jack.
2. Make sure your amp's volume is turned all the way down.
3. Connect the Left (Mono) output jack to your amp or other effects.
4. Turn on your amp.
5. Gradually increase your amp's volume until you reach a comfortable listening
level.
Connect your guitar to the
TimeBender
10
's Left input.
TM
Connect the TimeBender's
Left output to your amp's
input.
is capable of. This
TM
9VAC
1300mA
POWER