Universal Remote Control URC-L-1870 Manual page 7

2. Press the
release it.
3. Press the
and press the
4. The screen shows "DEV SEARCH" in the LCD menu, press the
confirm. Then press your desired device key (e.g.
the key to start the Auto
your device during the search).
5. See if the device reacts or not, once the device reacts, press any key to stop the
search.
6. Test if most of keys work good or not. If most keys work not good enough,
please repeat step 4~5.
7. If you satisfy the reactive code, please press the
shows "SUCCESS" then show "DEV SEARCH". You can press device key (e.g.
) again to finish set up or use
SET 3S
T V 0 1 0
1 1 : 4 5
A M
T V 0 1 0
Press any key to stop the search
S U C C E S S
Remark:
1. In case of you did not stop the search on time when device being reacted, you may
press the
2. The keys of
during the Auto Search, you can't control your device for menu function at the
moment until you finished set up.
..................................................................................................................
key on your new remote control for more than 3 seconds. Then
or keys to select to "CODE SET UP" in LCD menu,
key.
C O D E S E T U P
DVD
D V D 0 1 3
D V D
or key to search back to find the passed code.
,
Search (you must point your remote control to
or
check functions, if satisfied, press OK
0 3 5
are only used to set-up your new remote control
7
key) and then press
key to save it and LCD
to select other set up.
D E V S E A R C H
D V D 0 1 4
key to