Table of Contents
Advertisement
GEARBOX
The Gearbox has been filled with lubricant to the Test Plug Level prior to shipment. However, you should check
the oil level at Test Plug before operating, and frequently thereafter.
The gearbox should not require additional lubricant unless the box is cracked or a seal is leaking. It is
recommended that the oil level plug be removed after every 8 to 10 hours of operation and oil added until it
runs out Test Plug hole. The Test Plug is located on the rear of the Gearbox. Filler Plug is located on top of
Gearbox. Figures Mnt-0001, MntP-R-0025 & Mnt-R-0117.
OFFSET MODEL
Required lubricant is NLGI 000 Grease (P/N 00769030).
NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.
ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks, and refill
Gearbox as required.
TAIL WHEEL ASSEMBLY
Tail Wheel Bearings are packed at the factory with
heavy-duty bearing grease. Grease Fittings are
provided in the Wheel Hub and Tail Wheel Beam.
Grease after every 10 hours of use. Figure Mnt-R-
0101.
A96B 03/06
© 2006 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-3
STANDARD LIFT AND PULL
TYPE MODELS
Advertisement
Table of Contents
