Gearbox; Tail Wheel Assembly - Alamo Bush Hog BH300 Series Operator's Manual

Table of Contents

GEARBOX

The gearbox should be full and not require additional lubricant unless the box is cracked or a seal is

leaking. It is recommended that the oil level dipstick (Figure MntP-R-0278) be removed to check oil level

after every 8 hours of operation. If required, oil should be added until it comes to proper level.

Recommended lubricant is EP80W-90 or EP85W-140 Gear Oil.(See Table 1: GEARBOX OIL CAPACITY)

NOTE: Make sure mower is level when checking oil in the gearbox.

Do not over-fill. If gearboxes

are filled above the Dipstick

level, Pressure under working conditions may

cause grease seals to leak.

Tail Wheel Bearings are packed at the factory with

heavy-duty bearing grease. Grease Fittings are

provided in the Wheel Hub and Tail Wheel Beam.

Grease after 8 hours of use. Figure MntP-R-0191.

BH300 Series

12/21

12/21 Maintenance Section 5-4

MAINTENANCE

Maintenance Section 5-5

Tailwheel Beam

Lubrication

Wheel Bearing

Lubrication

MntP-R-0191

Table of Contents

Table of Contents