Table of Contents
Advertisement
3.3 Tractor Horsepower
The horsepower required to operate the mower depends on several operating factors including the vegetation
to be cut, terrain condition, operator experience, condition of the mower and tractor, and others. For most
mowing conditions, the A60B mower requires a tractor with a minimum of 30 HP and the A72B mower requires
a tractor with a minimum of 35 HP. Operating the mower with a tractor that does not have adequate power may
damage the tractor engine. Exceeding 75 HP may cause mower damage by overpowering the unit in heavy
cutting conditions.
3.4 3-Point Hitch
The tractor 3-point hitch must be rated to lift at least
850 lbs. if attaching an A60B and 1050 lbs. if
attaching an A72B mower.
A60B/72B mowers can attach to tractor's with
either a CAT I or II hitch. Refer to the tractor
operator's manual for the category of the tractor
used. If the hitch does not conform to ASAE Cat I or
II dimensions, the mower may not fit or raise
properly. Consult an authorized dealer for possible
modification procedures to mount nonconforming
hitches.
Use the correct hitch pins for the hitch category
being used. For a Cat I hitch, 7/8" lower and 3/4"
upper diameter hitch pins are used and Cat II
hitches require 1-1/8" lower and 1" upper diameter
hitch pins.
CAT I Implement / Hitch Specification
Width from outside to outside A-frame.... 26 7/8"
Quick Hitch width inside lug to lug ......... 27 1/8"
Height from bottom hitch pin to top pin ... 18"
Lower pin diameter ................................. 7/8"
Upper pin diameter ................................ 3/4"
Lynch pin diameter ................................. 15/32"
3.5 Front End Weight
A minimum of 20% total tractor weight must be maintained on the tractor front end at all times. Front end
weight is critical to maintain steering control and to prevent the tractor from rearing up while driving. If the
front end is too light, add weight until a minimum of 20% total weight is reached on the front tires. Front
weights and weight carriers can be purchased through an authorized tractor dealership. OPS-U- 0005
A60B/A72B 02/07
©2007 Alamo Group Inc.
OPERATION
CAT II Implement/ Hitch Specification
Width from outside to outside A-frame....32-3/8"
Quick Hitch width inside lug to lug ..........33-5/8"
Height from bottom hitch pin to top pin ...19"
Lower pin diameter .................................1-1/18"
Upper pin diameter .................................1"
Lynch pin diameter..................................15/32"
Operation Section 4-6
Advertisement
Table of Contents
