Description Of Parts; Instructions For The Power Supply Cord - Gaggia 10001695 User Manual

Description of parts:

FIG. 01
1
Main switch
2
Hot water/brew switch (pump)
3
On/off light
4 Steam switch (temperature)
5
Correct temperature light
6 Removable water tank
7
Steam/hot water knob
8 Turbo frother steam nozzle (removeable)
9
Filterholder
10 1 cup filter
11 2 cup filter
12 Basin (removable)
13 "Perfect cream" Filter (OPTION)
14 Brewing head
15 Filterholder gasket
16 Filter for pods
17 Shower disc
18 Tamper
19 Power cable and plug
20 Measuring spoon
21 Delivery spout
22 Tank cover
23 Grid (removable)
24 Cappuccino maker kit (OPTION)
25 Overflowing protection hole

Instructions for the power supply cord

A A short power-supply cord is provided to reduce risks of
getting tangled up or tripping over a longer cord.
B Longer extension cords are available and may be used if
care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension cord
should be at least as great as the electrical rating of
the appliance.
2 if the appliance is of the grounded type, the extension
cord should be a grounding type
3 the cable does not hang from the table to avoid the
risk of getting caught up in it.
Preparation:
1. Remove the water tank cover (22) and fill the tank with
cold water checking the level through the tank window
shown in FIG. 02.
N.B.: The upper section of the tank (6) is provided with an
overflowing safety hole (25) in case of tank overfilling.
The water tank can also be removed (FIG.02), after
removing the tank cover (22).
Re-install tank with water and cover (22).
2. Insert plug (19) into a suitable wall outlet (see point 1
under "Caution").
3. Press the main switch (1), the start light (3) will light
up.
The temperature light (5) will light up fixed when the
required temperature is reached;
Starting up
This procedure fills the water boiler with fresh water.
This should be done whenever the machine is switched on.
This machine, featuring a pump to brew coffee, is equipped
with a self-priming system.
Place an empty cup under the brewing head (14), do not
insert the filter holder and press the hot water/coffee switch
(2) ("1 Pos.).
You will hear the sound of the operating pump, and after
a few seconds, water will start flowing out of the brewing
head (14).
Warning! Before removing the water tank,
make sure that the machine is off as not to
damage the self-primer.
•  •
ENGLISH