Sony GXDL52H1 - 52" LCD Flat Panel Display Operating Instructions Manual page 76

For PC Input
PAP Setting
Multi Display
Aspect
Adjust Screen
Note
If there is no signal currently being input, none of the "Screen" settings options, except for "PAP Setting" and "Multi Display" can
be selected.
28
GB
See "PAP Setting" for video input (page 25).
See "Multi Display" for video input (page 26).
"Full 1": Select to enlarge the picture to fill the display area in the vertical direction,
keeping its original horizontal-to-vertical aspect ratio. A black frame will appear on
the surrounding of the picture.
"Full 2": Select to enlarge the picture to fill the display area.
"Real": Select to display the picture in its original number of dots.
Notes
• You cannot set the "Aspect" while using the "PAP" function or the "Multi Display"
function.
• If the input resolution is higher than the panel resolution (1,920 × 1,080), the display of Real
is the same as Full 1.
"Auto Adjustment": Select "OK" to automatically adjust the display position and
phase of the picture when the display receives an input signal from the connected PC.
Note that "Auto Adjustment" may not work well with certain input signals. In such
cases, manually adjust the options below.
"Phase": Select to adjust the phase when the screen flickers.
"Pitch": Select to adjust the pitch when the picture has unwanted vertical stripes.
Tip
"Auto Adjustment," "Phase," "Pitch" are not available when digital signal such as DVI or
HDMI is input.
"H Size": Allows you to adjust the size of the picture horizontally. Press G/g and
press to choose a correction.
"H Shift": Allows you to move the position of the picture left and right in the
window. Press G/g and press
"V Size": Allows you to adjust the size of the picture vertically. Press F/f and press
to choose a correction.
"V Shift": Allows you to move the position of the picture up and down in the
window. Press F/f and press
"Reset": Resets all settings of "Adjust Screen" to default settings.
When input is switched to PC input source, the
"Screen" settings specific for PC input are applied.
The "Screen" settings for a PC include the following
options:
to choose a correction.
to choose a correction.