Back Light Dimmer; Snooze Operation - Timex T248T User Manual

Note: Extend FM wire antenna fully for best FM reception. Rotate the unit, as required, for
best AM reception.
1. Press the On / Sleep Button on the top left to turn on the radio.
2. Set the Band Switch on the right side of the unit to the desired band, AM or FM.
3. Rotate the Tuning Control to select a station.
4. Press the On / Sleep Button again to change to sleep mode. The sleep timer will
automaticallyshut the radio off after a set time so you can fall asleep to the radio.
5. You can adjust sleep timer from 90, 60, 30 or 15 minutes by pressing the
Sleep Button to cycle through settings. The time setting and sleep icon will be
displayed.
6. To avoid affecting the normal alarm sound level, you can adjust the sleep volume by
pressing the
to show the volume setting.
7. To stop listening at any time press the
the unit.
1. To listen to Weather at any time, press the
LED on the front will light to indicate you are listening to Weather Band.
2. Set the Weather Band Channel Selector to the channel for your area. Adjust the
Volume Control as desired. Weather Band Channels:
Note: While listening to Weather, only the buzzer alarm will work/sound.
Note: Extend FM antenna and adjust direction for best Weather Band reception.
To adjust the display back lighting brightness, press the
Hi/Med/Low.
Press the Snooze/Dimmer Button after the alarm sounds, the alarm will go off and
will come on again in approximately 9 minutes. You may repeat this cycle several times
during the 1 hour alarm cycle.
Listening / Sleep to Radio
Sleep Volume Button as desired. The Sleep Volume icon will change
Instant Weather
Ch1 – 162.400MHz
Ch2 – 162.425MHz
Ch3 – 162.450MHz
Ch4 – 162.475MHz
Ch5 – 162.500MHz
Ch6 – 162.525MHz
Ch7 – 162.550MHz

Back Light Dimmer

Snooze Operation

Power Off/Alarm Reset Button to turn off
Weather Button. The
Snooze/Dimmer Button for
8
On /
Instant Weather