Furuno FA Manual page 211

7. Roll the trackball to place the cursor where you want to inscribe a waypoint
mark and then push the left button to inscribe the mark. The waypoint mark
(" " + waypoint number) appears at the location selected. (You can see the
range and bearing to the cursor location by monitoring the mark range and
bearing indication just below the MARK box.)
To enter another waypoint, push the right button when the guidance box reads
"MARK / EXIT" and then repeat steps 6-8. ("WPT" should be chosen on the
MARK menu.)
To quit entering waypoints, push the right button when the guidance box reads
"MARK / EXIT."
Entering waypoints by manual input of latitude and longitude
2. Roll the trackball to choose the MENU box at the right side of the screen and
then push the left button.
3. Roll the wheel to choose 8 [NAV LINE•WPT] and then push the wheel or the
left button.
[NAV LINE•WPT (1/2)]
1 BACK
2 NAV LINE DATA SOURCE
OFF/EXT DATA/
INTERNAL DATA/
WPT MARK
3 NAV LINE SELECT
- -
4 ARRIVAL WPT ALARM
OFF/ON 0.00NM
5 NAV LINE WIDTH
0.0NM
6 [WPT SET]
7 [WPT LIST]
8 [NAV LINE SET]
9 [NAV LINE LIST]
0 NEXT
NAV LINE•WPT menu
5. VIDEO PLOTTER OPERATION
5-21