Keyboard Control - CYBEX AUTOVIEW COMMANDER Installer/User Manual

AutoView Commander Installer/User Guide

Keyboard Control

The following notational conventions appear throughout this chapter to
illustrate commands for operating the AutoView. Whenever you see one of
the symbols listed on the left side of the table, substitute the corresponding
steps or values listed on the right side of the table.
Convention Key Sequence or Value
Enter Command Mode:
<CM> 1. Press and hold down the 'Num Lock' key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the 'Num Lock' key.
Note: For alternate hot-key sequences, see 'System Control &
Maintenance' later in this chapter.
<Enter> Press the 'Enter' or 'Return' key. The <Enter> command is used to
execute an instruction and exit from Command Mode.
Addr The letters over the push-buttons on your AutoView are your PCs'
addresses. Enter the letter, A-H, for the PC you're selecting. For
cascaded systems, enter the address of the base unit first.
Example : You have an AutoView unit cascaded from channel B of
your base unit. To access the PC at channel C of this second
(cascaded) unit, enter BC.
<ESC> Press the 'Escape' key. The <ESC> command is used to exit
Command Mode without executing an instruction.
10