Attach The Lens Cap - Panasonic Lumix DMC-G1 Operating Instructions Manual

Preparation
∫ Optical image stabilizer
Lens included in the DMC-G1K has a stabiliser function.
The optical image stabilizer function is set for activation when the lens is attached to the
camera body.
Set the [O.I.S.] switch to [ON].
•
You can change the optical image stabilizer mode to
[MODE1], [MODE2] or [MODE3] using [STABILIZER] in
the [REC] mode menu. (P100) It is set to [MODE1] at the
time of purchase.
•
We recommend setting the [O.I.S.] switch to [OFF] when
using a tripod. If the [O.I.S.] switch is set to [OFF], [
is displayed on the LCD monitor/Viewfinder.

Attach the lens cap.

Press the lens release button D while
turning the lens as far as possible in the
direction of the arrow to detach it.
•
Always attach the body cap to the camera body so
that dirt or dust does not get inside.
•
Attach the lens rear cap so that the lens contact
point does not get scratched.
Note
•
Change lenses where there is not a lot of dirt or dust. Refer to P138 when dirt or dust gets on
the lens.
•
When you turn the camera off or carry the camera, attach the lens cap to protect the surface of
the lens.
•
Be careful not to lose the lens cap, the lens rear cap and the body cap.
16
VQT1U32
Detaching a lens from the camera body
]