Panasonic Lumix DMC-G1 Operating Instructions Manual page 142

Others
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
• An error has occurred reading or writing the data.
> Turn the camera off and remove the card. Insert the card again and turn the camera on.
Make sure the camera is turned off before removing or inserting the card to avoid
damage.
•
Or try with a different card.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P119)
> Format the card after saving necessary data on a PC etc. (P34) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P32)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The video cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P32)
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P118,
120)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
> Check the printer.
[THE LENS IS NOT ATTACHED PROPERLY.]
•
Detach the lens and then attach it again. (P15)
[THIS BATTERY CANNOT BE USED]
•
Use the battery (DMW-BLB13PP) that can be used with the unit.
•
Detach the battery, and then attach it again. (P22) If the message is repeatedly displayed,
contact the retailer where you purchased the unit.
142
VQT1U32