Steering D/R; Atl Function - FUTABA 3PM Instruction Manual

When the steering angle is too small at under steering at corners while running, in-
crease the rate and when the steering angle is too large at over steering , decrease the
rate. The setup here is linked with transmitter grip lever DT3. Adjustments can be
made at this screen even if DT3 is assigned to another function.
Operation
- The steering servo left and right steering angles are adjusted simultaneously.
Calling the setup screen
(Initial screen)
Press "SEL" key to select the
desired function screen.
Steering D/R adjustment
1
(D/R value adjustment)
Use the (+) and (-) buttons to adjust the D/R value.
- This position is linked with the grip lever (DT3).
2
When ending adjustment, return to the initial screen by pressing the (SEL)
button.
This function adjusts the - side when the braking effect is strong and the + side when
the braking effect is weak. This setting is linked to transmitter grip lever DT4. When
DT4 is assigned to another function, set the ATL function with this screen.
Operation
The throttle brake side (when the throttle trigger is pushed
forward) brake amount can be adjusted.
Calling the setup screen
(Initial screen)
Press "SEL" key to select the
desired function screen.
44
Steering Dual Rate / D/R-ST
(Setup screen)
Setup Item
D/R: Steering D/R value
D/R value
0 ~ 100%
Initial value: 100%
Throttle ATL Function / ATL-BK
(Setup screen)
Dual Rate value
When Dual Rate lever is operated, the
" D / R - S T " s c r e e n i s d i s p l a y e d
automaticaly for about three seconds.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to the
initial screen.
ATL position
When ATL lever is operated, the "ATL-
BK" screen is displayed automaticaly
for about three seconds.