FUTABA 3PM Instruction Manual page 30

Calling the setup screen
(Initial screen)
Press "SEL" key to select the
desired function screen.
Steering (EPA) adjustment
(Preparation)
- Before setting up the steering wheel EPA, set the steering D/R lever (initial setup:
DT3) to the maximum steering angle position 100%.
- Select setup item "ST" and make the following adjustments:
1
Steering (left side) adjustment
Turn the steering wheel fully to the left and use the (+) and (-) buttons to
adjust the steering angle.
2
Steering (right side) adjustment
Turn the steering wheel fully to the right and use the (+) and (-) buttons to
adjust the steering angle.
3
When adjusting the EPA of another channel immediately after this, see the
adjustment method for that channel. When ending adjustment, return to
the initial screen by pressing the (SEL) button.
Throttle (EPA) adjustment
(Preparation)
- Before setting the throttle EPA, set the throttle ATL lever (initial setup: DT4) to the
maximum steering angle position 100%.
- Select setup item "TH" and make the following adjustments:
1
Throttle (forward side) adjustment
Pull the throttle trigger fully to the high side and use the (+) and (-) buttons to adjust
the steering angle. However, when using an FET amp, set to 100%.
(Setup screen)
Setup items
ST-L.F.U : Steering (left side)
ST-R.B.D : Steering (right side)
TH-L.F.U : Throttle (forward side)
TH-R.B.D : Throttle (brake side)
3C-L.F.U : 3rd channel (up side)
3C-R.B.D : 3rd channel (down side)
Press "CH" key to select the next set-
up screen.
Adjustment range
0~120% (each channel, each direc-
tion)
Adjustment buttons
- Use the (+) and (-) keys to make ad-
justments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
31