Throttle Acceleration - FUTABA 3PJ Super Instruction Manual

Gas powered cars require a slight clearance in the linkage. Therefore, there is a lag
time at both the forward and brake sides. The response of an electric car is obtained
by reducing this time lag at the transmitter.
A slight clearance is required at the linkage, but the
throttle acceleration function acts to reduce the time
lag caused by this clearance.
1. (Forward side setting)
Call the throttle acceleration
function set-up screen by
pressing the UP key five
times at the initial screen.
2. Adjust the forward side with
the + or - key.
3. (Back side setting)
Call the back side set-up
screen by pressing the SE-
LECT key once.
4. Adjust the back side with the
+ or - key.
56

Throttle Acceleration

Operation
- Sharply increases the throttle response near the throttle
trigger neutral position.
- The forward side and brake side can be adjusted indepen-
dently.
Carburetor
Servo horn
Brake side
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
- 5 times
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
+
UP
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP +
SETUP RESET
-
SELECT DOWN
TH.EXP ATV CUSTOM
Blink
Setting range: 0~100%
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.
Blink
Setting range: 0~100%
- Return to the initial value (0%) by
pressing the + and - keys simulta-
neously for about one second.