Transmitter Set-Up Procedures - FUTABA 2PL-2.4GHZ Instruction Manual

Transmitter Set-Up Procedures

*When making these settings adjustments, do so with the motor disconnected or
the engine not running.
(Preparations)
Select the model memory that is not used and reset it to the initial values with the model
selection and model reset functions.
Model Selection
Servo Horn Installation Instructions
1 Connect the receiver, servos, and other components and
then turn on the power switches to transmitter and receiver.
*Both servos will move to the neutral position.
2 At this time install the servo horn in the manner described in
the instruction manual provided with the model this system
will be used in.
Reversing The Servo Operation Direction
Should the ser vo operate in the opposite
direction required for your application, reverse
the direction with the servo reversing.
E.S.C. MC230CR / MC330CR
NEUTRAL, HIGH, AND BRAKE MAX POINTS SETTINGS
Set the steering angle adjustment function (ATV) to
100% and the ABS function and acceleration function
to OFF using the transmitter throttle channel function.
If the steering angle is too large or the ABS and acceleration
functions are on, erroneous operation may occur.
Before setting each point, set the transmitter throttle channel trim to neutral.
1
Turn on the power in transmitter -> amp order.
Transmitter throttle operation
2
Neutral point
setting
3
High point
setting
Full High
4
Brake MAX
point setting
* Since the data is read at the end of setting of all points, the points cannot be set independently.
* If the amp power was turned off during setting, the setting points cannot be memorized. (The previous settings are retained.)
* The confirmation beep sounds only when the motor was connected.
Model number
1 - 0
(Selection key)
Model name
(Pushbutton switch operation)
Press the pushbutton switch.
Neutral state
(0.5 secs or longer)
N
(Confirmation beep sounds)
Press the pushbutton switch.
Full high state
(Confirmation beep sounds)
N
Full brake state
Press the pushbutton switch.
(Confirmation beep sounds.)
N Full brake
Model Reset
Push the DT2 lever up or down
for about one second.
All data stored in the current
selected model memory is
erased.
*When using the ABS function, after setting up
the MC230CR / MC330CR, stop the reverse
function, then turn on the ABS function. If the
ABS function is on, the MC231CR / MC331CR
cannot be set up correctly.
MC230CR /MC330CR
(Checker LED)
Continuous single blink
Continuous double blink
If the LED goes out,
setting is complete.
Assembly / Adjustment
Steering Servo Reverse
NOR: Normal
REV: Reverse
Throttle Servo Reverse
NOR: Normal
REV: Reverse
If the LED does not go off
but blinks rapidly, setting
was not performed
normally. Repeat setting
from "Neutral point
setting".
Continuous rapid blink
(Selection key)
(Selection key)
15