Transmitter Set-Up Procedures - FUTABA 2HR Instruction Manual

*When making these settings adjustments, do so with the motor disconnected or
the engine not running.
Servo Horn Installation Instructions
1 Connect the receiver, servos, and other components and
then turn on the power switches to transmitter and receiver.
*Both servos will move to the neutral position.
2 At this time install the servo horn in the manner described in
the instruction manual provided with the model this system
will be used in.
Reversing The Servo Operation Direction
Should the ser vo operate in
the opposite direction required
for your application, reverse
the direction with the ser vo
reversing.
E.S.C. MC231CR / MC331CR
NEUTRAL, HIGH, AND BRAKE MAX POINT SETTINGS
Before setting each point, set the transmitter throttle channel trim to neutral.
1
Turn on the power in transmitter
2
Neutral point
setting
3
Full high
High point
setting
4
Brake MAX
point setting
Full brake
* Since the data is read at the end of setting of all points, the points cannot be set independently.
* If the amp power was turned off during setting, the setting points cannot be memorized. (The previous settings are retained.)
* The confirmation beep sounds only when the motor was connected.
22
Assembly / Adjustment

Transmitter Set-Up Procedures

amp order.
Transmitter throttle operation
･Neutral state
･Full high state
･Full brake state
Throttle Servo
Reversing
NOR: Normal
REV: Reverse
MC231CR
(Pushbutton switch operation)
･Continuous single blink
･Press the pushbutton switch.
(0.5 secs or longer)
(Confirmation beep sounds)
･Continuous double blink
･Press the pushbutton switch.
(Confirmation beep sounds)
･If the LED goes out,
･Press the pushbutton switch.
(Confirmation beep sounds.)
Steering Servo
Reversing
NOR: Normal
REV: Reverse
(Checker LED)
If the LED does not go off
but blinks rapidly, setting
was not performed
normally. Repeat setting
from "Neutral point
setting is complete.
setting".
･Continuous rapid blink