FUTABA 2PL-2.4GHZ Instruction Manual page 2

Thank you for purchasing a Futaba FHSS 2PL 2.4GHz system.
This system is based on the combination of the newly developed 2.4GHz transmitter
and its correspondent receiver. Before using your 2PL 2.4GHz system, read this manual
carefully and use your R/C set safely.
After reading this manual, store it in a safe place.
FHSS 2PL 2.4GHz system
•2.4GHzSS (Spread Spectrum) radio communication system
•Frequency channel setting unnecessary: Sifting the channels within the 2.4GHz band automatically, this
system minimizes the interference from other 2.4GHz system.
•Accepts no unwanted signals by using ID code
•Built-in antenna (T2PL-2.4G transmitter)
1. This product may be used for models only. It is not intended for use in any application other than the
control of models for hobby and recreational purposes.
2. Exportation precautions:
(a) When this product is exported from the country of manufacture, its use is to be approved by the laws
governing the country of destination which govern devices that emit radio frequencies. If this product is
then re-exported to other countries, it may be subject to restrictions on such export. Prior approval of the
appropriate goverment authorities may be required. If you have purchased this product from an exporter
outside your country, and not the authorized Futaba distributor in your country, please contact the seller
immediately to determine if such export regulations have been met.
(b) Use of this product with other than models may be restricted by Export and Trade Control Regulations,
and an application for export approval must be submitted.
3. Modification, adjustment, and replacement of parts: Futaba is not responsible for unauthorized
modification, adjustment, and replacement of parts on this product. Any such changes may void the
warranty.
Compliance Information Statement (for U.S.A.)
This device, trade name Futaba Corporation of America, model number R603GF, complies with part 15 of
the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
The responsible party of this device compliance is;
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@futaba-rc.com (Support)
TEL (217)398-0007 or E-mail: service@futaba-rc.com (Service)
Battery Recycling (for U.S.A.)
The RBRC
products indicates that Futaba Corporation of America is voluntarily participating in an
industry program to collect and recycle these batteries at the end of their useful lives, when
taken out of service within the United States. The RBRC
alternative to placing used nickel-cadmium batteries into the trash or municipal waste system, which is
illegal in some areas.
You may contact your local recycling center for information on where to return the spent battery. Please
call 1-800-8-BATTERY for information on Ni-Cd battery recycling in your area. Futaba Corporation
of America's involvement in this program is part of its commitment to protecting our environment and
conserving natural resources.
TM
RBRC is a trademark of the Rechargeable Battery Recycling Corporation.
TM
SEAL on the (easily removable) nickel-cadmium battery contained in Futaba
TM
program provides a convenient