Table of Contents
Advertisement
IN0
IN1
Note:
Please set up the function switch when the power is switched off. After the setup is completed, re-power
RTU-DNET.
When RTU-DNET is operating, changing the setting of the function switch will be invalid.
Use slotted screwdriver to adjust the DIP switch carefully in case you scratch the switch.
2.7 Extension Port
The extension port is used on connecting RTU-DNET to DVP Slim DI/DO extension units and special modules.
3
Basic Operation
3.1 Connecting RTU-DNET to DVP Slim DI/DO Extension Unit
Open the fixing clips on top and bottom of RTU-DNET. Meet the extension port of Slim DI/DO with RTU-DNET.
Press the fixing clips on top and bottm of Slim DI/DO and check if the connection is fine.
3.2 Installing RTU-DNET and DVP Slim DI/DO on DIN Rail
Use 35mm DIN rail.
Open the DIN rail clip on RTU-DNET and Slim DI/DO. Insert RTU-DNET and Slim DI/DO onto the DIN rail.
Clip up the DIN rail clips on RTU-DNET and Slim DI/DO to fix them on the DIN rail, as shown below.
DVP-PLC Application Manual
DeviceNet Remote I/O Communication Module RTU-DNET
When DeviceNet is off, the I/O data in
OFF
the buffer area will be cleared.
When DeviceNet is off, the I/O data in
ON
the buffer area will be held.
Reserved
35mm DIN rail
7
Advertisement
Table of Contents
