Wds With Ap Mode - D-Link DAP-2553 - Wireless N Dual Band Gigabit Access Point User Manual

Section 3 - Configuration
In WDS with AP mode, the DAP-2553 wirelessly connects multiple networks while still functioning as a wireless AP.
Wireless Band: Select either 2.4GHz or 5GHz from the drop-down
menu.
Mode:
WDS with AP mode is selected from the drop-down
menu.
Network Name
Service Set Identifier (SSID) is the name designated
(SSID):
for a specific wireless local area network (WLAN). The
SSID's factory default setting is dlink. The SSID can
be easily changed to connect to an existing wireless
network or to establish a new wireless network.
SSID Visibility:
Enable or Disable SSID visibility. Enabling this feature
broadcasts the SSID across the network, thus making
it visible to all network users.
Auto Channel
Enabling this feature automatically selects the channel
Selection:
that will provide the best wireless performance. This
feature is not supported in WDS with AP mode. The
channel selection process only occurs when the AP
is booting up.
Channel:
All devices on the network must share the same
channel. To change the channel, use the drop-down
menu to make the desired selection. (Note: The
wireless adapters will automatically scan and match
the wireless settings.)
Channel Width: Allows you to select the channel width you would like to operate in. Select 20 MHz if you are not using any 802.11n
wireless clients. Auto 20/40 MHz allows you to connect to both 802.11n and 802.11b/g or 802.11a wireless devices on your
network.
D-Link DAP-553 User Manual

WDS with AP mode

0