Canon Wireless Transmitter WFT-E5A Instruction Manual page 71

Set up the master camera.
5
Configure the settings on the master camera
following steps 1-3 on the previous page, and then
select [Master].
The following screen is displayed.
At this point, switch to setting up the
6
slave cameras.
On the slave cameras, select [OK].
Check the number of slave cameras.
7
On the master camera LCD monitor, the number of
slave cameras detected is displayed.
Establish the connection.
8
On the master camera and all slave cameras,
select [OK].
A screen is displayed as the connection is tested.
The information you specified is stored on the
cameras. It is not stored on the transmitters.
Setting Up Linked Shooting
71